- 69 -
• Multiple Part High Density Print Area
Enables setting the “Multiple Part High Density Print Area Offset (c)” (X-coordinate of the multiple part high
density print area start position) and “Multiple Part High Density Print Area Length (d)”.
This area is to be printed with much higher print energy than the multiple part print area to enable clearly
printing small or fine characters and bar codes on the second sheet. The extra energy level can be
specified by entering a value in the “Multiple Part Area High Density Adjustment” box. (If the “Multiple Part
Area High Density Adjustment” is set to “0”, which means no difference, and both areas are printed with the
same print density.)
• Multiple Part High density Print Area Offset: 0.0mm to 390.0mm
• Multiple Part High density Print Area Length: 0.0mm to 390.0mm
• Multiple Part Print Area High Density Adjustment
Enables specifying how much extra energy is applied for the “Multi Part Print High Density Area” than the
“Multiple Part Print Area”.
• Multiple Part Print Area High Density Adjustment: 0 to 10
Supplement:
1. Duplicate printing is available only to double-layer thermal paper. Triple- or more layer paper is not accepted.
2. If the print on the second sheet is too light, specifying this print area as a Multiple Part High De nsity Print Area. Doing
this improves the print result.
3. It is possible to specify a Multiple Part Print Area and a Multiple Part High Density Print Area independently.
4. It is not necessary to specify both the Multiple Part Print Area and the Multiple Part High Density Print Area.
5. The Multiple Part High Density Print Area is not necessarily within a Multiple Part Print Area.
6. The Print Density Adjustment value, set in the Options page, is reflected in the Multiple Part Print Area a Multiple Part
High Density Print Area.
● Print density of normal print area =
● Print density for the Multiple Part Print Area =
● Print density for the Multiple Part High Density Print Area =
: Print density adjustment value
: Standard print density for the Multiple Part Print Area
: Fine adjustment value for the Multiple Part High Density Print Area