Toshiba RAS-10GAVP-E Required tools for installation work, Appendix-2, Part name, Q’ty, Usage

Appendix

No.	Part name	Q’ty	Specifications/Vendor	Remarks
13	Power cord	1	2-cores x 0.75mm² or more, H05RN-F	Procured locally
14	Thermostat	1	Material: SGCC-Z08, Board thickness: 0.8t	Procured locally
	fixing plate			(Drawing attached)
15	PVC tube	1	Inside diameter Ø8 x outside diameter Ø11 x 70 mm	Procured locally
16	Shield tube	1	Inside diameter Ø18 x outside diameter Ø26 x 70 mm	Procured locally
			Material: Polyethylene foam
17	Bundling tie	1	Bundling tie for securing the wires	Procured locally
			Material: 6/6 nylon

NOTE: The parts on the above table are recommended parts.

2. Required tools for installation work

No.	Part name	Specifications	Usage
1	Plus screwdriver		It is used for disassembling and assembling of each cabinet.
2	Wrench		It is used for disassembling and assembling of compressor fixing nuts.
3	Motor drill	Drill diameter:	It is used to make the additional holes on the base or the side cabinet
		Ø3.2 and Ø5.0	(R).
4	Faston crimping tool	Fixing jig for #250
5	Close-end connec-
	tor crimping tool
6	Cutting plier
7	Stripper
8	Cutter knife
9	Insulation tape
10	Metal-cutting shears		It is used to process the side cabinet (L).

Appendix-2