Toshiba RAS-13GAVP-E Appendix-6, Photo / Explanatory diagram, Procedure, these screws

Appendix

No.	Photo / Explanatory diagram	Procedure
	Cord heater installation work
2	Drill a hole on the outdoor unit base plate, and fix the cord heater to the outdoor unit base plate using P-shape
	clamp.
	Connect the cord heater cables.
	Using a motor drill, etc., drill Ø3.2 holes on the outdoor unit base plate. (12 positions) See Appendix-10 for the
2-1	additional hole positions.

These holes are used to fix the cord heater to the outdoor unit base plate with P-shape clamp.

										Insert the PVC tube into the cord heater.
										This tube is designed to protect the cord heater from
										the fixing screws used to secure the anchoring feet.
										As shown in the left figure, install the cord heater
										(1.5m) to the outdoor unit base plate by using P-
										shape clamp and screws (Self-tapping screw type-B
										Ø4 × 6mm, stainless).
										Pay attention to the direction of P-shape clamp so
										that it is set to the same direction in the left figure.
				The PVC tube must be inserted
					into the cord heater between
			the fixing screws in order to						* If the drain port is frozen due to installation
					protect the cord heater from
										status, etc., draw around the cord heater so that
2-2					these screws.
						Under no circumstances must				the end part of the heater is inserted into the
	PVC tube									drain port. In this case, add some fixing
			the tube be allowed to ride over
			the tip of the fixing screws.							positions to fix the cord heater surely.
		Ø9.1 P-shape clamp
										* The end part from the marked part of the cord
										heater heats up. When there is the heating part
										near the electric parts box, a fire may generate.
										Be sure to set the heating part on the outdoor
										unit base plate at the fan room side or near it.
										(within 20cm from the outdoor unit base plate)
									Enlarged	* Be careful that the cord heater does not hit the
										fan.
		Heating part
									marked part	Fix the cord heater without any loosening or sag.
								5		Drill a hole on the side cabinet (R) for fixing the
			Added hole 2-				φ			thermostat fixing plate.

5	Ø5 hole at two positions
	When drilling a hole on the side cabinet (R), be
46	sure not to damage the cabinet.

7

2-3

Side cabinet (R)

Appendix-6