Toshiba RAS-13GAVP-E Flare tool for R410A Conventional flare tool, Clutch type Wing nut type

d) Flare Processing

Make certain that a clamp bar and copper pipe have been cleaned.

By means of the clamp bar, perform the flare processing correctly.

Use either a flare tool for R410A or conven- tional flare tool.

Flare processing dimensions differ according to the type of flare tool. When using a con- ventional flare tool, be sure to secure “dimen- sion A” by using a gauge for size adjustment.

ØD

A

Fig. 3-2-1 Flare processing dimensions

Table 3-2-3 Dimensions related to flare processing for R410A

	Outer			A (mm)
Nominal		Thickness
	diameter		Flare tool for R410A	Conventional flare tool
diameter		(mm)
	(mm)
			clutch type	Clutch type	Wing nut type
1/4	6.35	0.8	0 to 0.5	1.0 to 1.5	1.5 to 2.0
3/8	9.52	0.8	0 to 0.5	1.0 to 1.5	1.5 to 2.0
1/2	12.70	0.8	0 to 0.5	1.0 to 1.5	2.0 to 2.5
5/8	15.88	1.0	0 to 0.5	1.0 to 1.5	2.0 to 2.5
	Table 3-2-4 Dimensions related to flare processing for R22
	Outer			A (mm)
Nominal		Thickness
	diameter		Flare tool for R22	Conventional flare tool
diameter		(mm)
	(mm)
			clutch type	Clutch type	Wing nut type
1/4	6.35	0.8	0 to 0.5	0.5 to 1.0	1.0 to 1.5
3/8	9.52	0.8	0 to 0.5	0.5 to 1.0	1.0 to 1.5
1/2	12.70	0.8	0 to 0.5	0.5 to 1.0	1.5 to 2.0
5/8	15.88	1.0	0 to 0.5	0.5 to 1.0	1.5 to 2.0

Table 3-2-5 Flare and flare nut dimensions for R410A

Nominal	Outer diameter	Thickness		Dimension (mm)				Flare nut width
diameter	(mm)	(mm)	A		B	C	D	(mm)
1/4	6.35	0.8	9.1		9.2	6.5	13	17
3/8	9.52	0.8	13.2		13.5	9.7	20	22
1/2	12.70	0.8	16.6		16.0	12.9	23	26
5/8	15.88	1.0	19.7		19.0	16.0	25	29

– 9 –