Toshiba RAS-13GAVP-E, RAS-B16GKVP-E, RAS-B13GKVP-E Part name Procedure, Parts name Qty Remarks

No.	Part name		Procedure
15	Replacement of	1)	Cut the sensor 100 mm longer than old
	temperature sensor		one.
	for servicing only	2)	Cut the protective tube after pulling out
			it (200 mm).
	Common service	3)	Move the protective tube toward the
	parts of sensor TO,		thermal sensor side and tear the tip of
	TS, TE, TD
			lead wire in two then strip the covering
			part.
		4)	Pass the stripped part through the
			thermal constringent tube.
		5)	Cut the old sensor 100 mm length on
			the connector side, and recycle that
			connector.
		6)	Tear the lead wire in two on the con-
			nector side and strip the covering part.

	Remarks
Thermal	Cutting here
	Connector	100
sensor part

200Cutting here

	15
Thermal	70

constringent tube

Cutting here 100

7)Twist the leads on the connector and sensor sides, and solder them.

8)Move the thermal constringent tubes toward the soldered parts and heat them with the dryer and constring them.

9)Wind the attached color tape round the both terminals of the protective tube when colored protective tube is used.

10)Fix the sensor again.

NOTE

15	Soldered part
70

Dryer

Winding the color tape

These are parts for servicing sensors.

Please check that the accessories shown in the right table are packed.

1)Store the joint part of the sensor and the connector in the electric parts box.

2)Never joint them near the thermal sensor part. Otherwise it would cause insulation inferiority because of dew drops.

3)When replacing the sensor using the colored protective tube, wind the color tape matching the color of that tube.

	Parts name	Q'ty	Remarks
1	Sensor	1	Length : 3m
2	Sensor Spring (A)	1	For spare
3	Sensor Spring (B)	1	For spare
4	Thermal constringent tube	3	Including one spare
5	Color tape	1	9 colors
6	Terminal	3

– 99 –