Toshiba RAV-SM560XT-E, RAV-SM800XT-E Cutting a hole and mounting the Installation plate, Axis

9-5-5. Console Installation

•Select the terminal of Selector-SW from [C position] to [F position].

C F

INSTALL

A B

REMOCON

<Install the indoor unit>

•Install the Installation plate 1 at the wall according to the Paper pattern.

•Hang the indoor unit on the hooks of the Installation plate 1.

•Fix the lower portion of the indoor unit with Mounting screws 4 (2 places).

Indoor unit

Hook

1Installation plate

Fig. 9-5-18

<Cutting a hole and mounting the Installation plate>

•When installing the rear piping, determine the pipe hole position, drill the pipe hole (∅80 mm) at a slight downward slant to the outdoor side.

4Mounting screw

•For mounting of the Installation plate 1, use the

Paper pattern, which is inside the package box cover.

		1093	375 mm
		742	or more
	160		633	4 Mounting screw
390mm	ormore	320		Fig. 9-5-21
			60	<Condition for installation>
			140	• The unit must not decline more than 15 mm in either
		Floor	Rear piping hole ∅80	axis.
				15 mm

Fig. 9-5-19

Anchor bolt

Projection

15 mm or less

5 mm dia. hole

4Mounting screw ∅4 x 25 s

Clip anchor (local parts)

Fig. 9-5-20

CAUTION

Failure to firmly install the unit may result in personal injury and property damage if the unit falls.

•In case of block, brick, concrete or similar type walls, make 5 mm dia. holes in the wall.

•Insert clip anchors for appropriate Mounting screws

4.

Fig. 9-5-22

<Piping and Drain Hose Installation>

•The piping direction can be the following 3 ways with the Drain hose.

•Each piping direction

should be connected with the Flexible pipe 5.

Rear piping

Side piping

Bottom piping

Fig. 9-5-22

•Cut or remove the determined direction slit or cover.

NOTE :

•Secure four corners and lower parts of the Installation plate 1 with 6 to 8 mounting screws to install it.

– 35 –

	Slit for upper
Cover for	piping
side piping	Cover for rear
	upper piping

Fig. 9-5-23