TL-WR1042ND 300Mbps Wireless N Gigabit Router
Figure 4-50 Add or Modify a Triggering Entry
¾Trigger Port - The port for outgoing traffic. An outgoing connection using this port will trigger this rule.
¾Trigger Protocol - The protocol used for Trigger Ports, either TCP, UDP, or All (all protocols supported by the Router).
¾Incoming Port - The port or port range used by the remote system when it responds to the outgoing request. A response using one of these ports will be forwarded to the PC which triggered this rule. You can input at most 5 groups of ports (or port sections). Every group of ports must be separated with ",", for example,
¾Incoming Protocol - The protocol used for Incoming Port, either TCP, UDP, or ALL (all protocols supported by the Router).
¾Status - The status of this entry, Enabled means the Port Triggering entry is enabled.
¾Modify - To modify or delete an existing entry.
¾Common Applications - Some popular applications already listed in the
To modify or delete an existing entry:
1.Find the desired entry in the table.
2.Click Modify or Delete as desired on the Modify column.
Click the Enable All button to make all entries enabled.
Click the Disabled All button to make all entries disabled.
Click the Delete All button to delete all entries
Once the Router is configured, the operation is as follows:
1.A local host makes an outgoing connection to an external host using a destination port number defined in the Trigger Port field.
