)Note:
After a device is successfully added to the network by QSS function, the QSS LED will keep on for about 5 minutes and then turn off.
1.4.2The Rear Panel
Figure 1-2 Rear Panel sketch
The following parts are located on the rear panel (View from left to right).
¾POWER: The Power socket is where you will connect the power adapter. Please use the power adapter provided with this
¾RESET:
There are two ways to reset to the Router's factory defaults:
1)Use the Factory Defaults function on System Tools
2)Use the Factory Default Reset button: Press the Reset button for five seconds and then wait for the Router to reboot.
¾USB: Connect with USB Mass Storage Device.
¾WAN: This WAN port is where you will connect the DSL/cable Modem, or Ethernet.
¾1,2,3,4 (LAN): These ports (1, 2, 3, 4) connect the Router to the local PC(s).
¾Wireless antenna: To receive and transmit the wireless data.
