TP-Link TL-WR702N manual Panel Layout, ¾ LED, Status, Indication, 150Mbps Wireless N Nano Router

TL-WR702N

150Mbps Wireless N Nano Router

1.4 Panel Layout

		Figure 1-1 TL-WR702N sketch
¾ LED
	Status	Indication
	Solid	It’s powered on but the LAN/WAN port is not connected.
	Flashing	The LAN/WAN cable is connected but there is no data
	Slowly	being transmitted or received.
	Flashing	The LAN/WAN cable is connected and there is data being
	Quickly	transmitted or received.
		Table 1-1 The LED Description

¾LAN/WAN: This LAN/WAN port works as LAN in AP/Repeater/ Bridge/Client mode and as WAN in Router mode. As LAN, it connects the Router to the local PC; as WAN, it enables you connect the DSL/cable Modem, or Ethernet.

¾Power: This port is used to connect the provided power adapter.

¾Reset：It is used to reset the Router to its factory defaults. With the Router powered on, use a pin to press and hold the Reset button (about 5 seconds) until the SYS LED becomes quick-flash from slow-flash. And then release the button and wait the Router to reboot to its factory default settings.

- 4 -