TP-Link TL-WR702N manual 150Mbps Wireless N Nano Router

TL-WR702N

150Mbps Wireless N Nano Router

Figure 4-15 DHCP Settings

¾DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you must have another DHCP server within your network or else you must configure the computer manually.

¾Start IP Address - Specify an IP address for the DHCP Server to start with when assigning IP addresses. 192.168.0.100 is the default start address.

¾End IP Address - Specify an IP address for the DHCP Server to end with when assigning IP addresses. 192.168.0.199 is the default end address.

¾Address Lease Time - The Address Lease Time is the amount of time a network user will be allowed connection to the Router with their current dynamic IP Address. Enter the amount of time in minutes and the user will be "leased" this dynamic IP Address. After the time is up, the user will be automatically assigned a new dynamic IP address. The range of the time is 1 ~ 2880 minutes. The default value is 120 minutes.

¾Default Gateway (Optional) - It is suggested to input the IP address of the LAN port of the Router. The default value is 192.168.0.254.

¾Default Domain (Optional) - Input the domain name of your network.

¾Primary DNS - (Optional) Input the DNS IP address provided by your ISP or consult your ISP.

¾Secondary DNS (Optional) - Input the IP address of another DNS server if your ISP provides two DNS servers.

)Note:

To use the DHCP server function of the Router, you must configure all computers on the LAN as "Obtain an IP Address automatically".

- 42 -