TP-Link TL-WR702N manual Client Mode, 150Mbps Wireless N Nano Router, 20 Quick Setup - Finish

TL-WR702N

150Mbps Wireless N Nano Router

Figure 3-19 Quick Setup - Wireless Security Settings

This page is for setting wireless security of your own AP. When computers and mobile phones are connected to the AP, they should input the same password.

¾Disable Security - The wireless security function can be enabled or disabled. If disabled, the wireless stations will be able to connect the Router without encryption. It is recommended strongly to enable security.

¾PSK Password - ou can enter ASCII or Hexadecimal characters. The default password is the last unique eight numbers of each Router’s MAC address

For ASCII, the key can be made up of any numbers 0 to 9 and any letters A to Z, the length should be between 8 and 63 characters.

For Hexadecimal, the key can be made up of any numbers 0 to 9 and letters A to F, the length should be between 8 and 64 characters.

Please also note the key is case sensitive, this means that upper and lower case keys will affect the outcome. It would also be a good idea to write down the key and all related wireless security settings.

3.Click the Next button in Figure 3-20.You will then see the Finish page. Click the Reboot button to make your wireless configuration take effect and finish the Quick Setup.

Figure 3-20 Quick Setup - Finish

3.2.5 Client Mode

When you choose Client on Working Mode page in Figure 3-5 , take the following steps:

1.Click Next in Figure 3-5,and then Wireless Client page will appear as shown in Figure 3-21.

- 24 -