CONVERSip EP100 User
6.Dial reminder time using the numbers on the dial pad (remem- ber to dial a zero before single digit times: 01 for one o’clock, 02 for 2 o’clock, etc.).
7.Set AM or PM.
8.Select SAVE.
9.Press SPEAKER to quit.
Time: 10:30 AM
SAVE PM EXIT
Setting the Alert Time
When an alert sounds at the set time, you hear four short tone bursts, which continues until acted upon. If you are not at your station to hear the alert when it sounds, your telephone’s ring tone changes to the alert tone for every incoming call until you respond to the alert.
To respond to an alert after it sounds, choose one of the following:
1.Select CLEAR to turn off the alert.
2.Select SET to reset the alert for the same time the following day.
ALERT 1 | 10:30 AM | |
| SET | CLEAR |
Responding to an Alert
6.6 Response Message Button
You may program a RESPONSE MESSAGE button, which allows you to send an LCD message to a caller who has initiated a SOHVA or intercom call from another LCD speakerphone. It also allows you to send an LCD message to another LCD speakerphone when you call and receive a busy signal or no answer.
To store a scrolling RESPONSE MESSAGE button, proceed as follows (user may press button repeatedly to choose from up to 30 system supplied messages),
1.Press INTERCOM.
2.Dial **6.
Sept ‘04 | Comdial | 79 |
