Vertical Communications EP100 manual Paging

CONVERSip EP100 User

To maintain the extension number and programming features from the old location,

1.Connect the telephone line cord to the new jack.

2.Observe the flashing HOLD light and press HOLD while the light is still flashing (your telephone immediately assumed the features from the previous location).

Note: If you do not select a button after installing the telephone, the system automatically defaults to the programming from the previous location.

To assume the extension number and programming features from the new location,

1.Connect the telephone line cord to the new jack.

2.Observe the flashing HOLD light and dial # while the light is still flashing (your telephone immediately assumes the features from the new location).

7.13 Paging

Your system provides an all-call or a zone page feature that you access by dialing special codes. This arrangement sounds your voice announcement through the telephone speakers or through an external paging unit.

To send a paging announcement,

1.Lift handset.

2.Press INTERCOM.

3.Dial 70 through 77 for zones 1–8. Note: Zone 1 (code 70) provides an all-call function in the default mode.

4.Make announcement.

5.Remain on line if awaiting a reply (known as a Meet-Me page), or hang up handset.

Sept ‘04 Comdial 95