Xerox N4525 manual Control Panel Messages, Advanced Features and Troubleshooting Manual

	Control Panel Messages
Error	Description and corrective action
Enter Password	Appears when using the Password Menu to print or delete secure and proof
_xxx	jobs. Jobs Print or Jobs Delete.
	■ Enter a valid 4-digit password using the control panel’s keys, then proceed
	to print or delete the secure and proof jobs that have that password.
	■ If you want to exit the Password menu, press the Menu keys (labeled 1 or 5).
	To exit the menu system, press the On Line key (labeled 0).
Env. Feeder	The Envelope Feeder is empty.
Empty	■ Refill the Envelope feeder if it is to be used again.
Env. Feeder Fail	The 100 Envelope Feeder has failed so printing from it cannot continue.
Power Off/On	■ Power OFF the Printer, remove and re-install the Envelope Feeder, power
	ON the printer.
	■ If the Envelope Feeder still fails, contact your Customer Support Center.
Fan Failure	The fan is not working.
Power OFF NOW!	■ Power OFF the printer immediately and contact your Customer Support
	Center.
Finisher Failure	Problem in the Finisher.
Power Off/On	■ Power OFF and ON the printer.
	■ If the Finisher still fails, contact your Customer Support Center.
Flash Error	A Flash Memory error was found.
Format Flash	■ Format flash memory as per the instructions on page 54.
	■ If the problem persists, contact your Customer Service Center.
Flushing...	Tells you that the PostScript print job could not be printed and is being parsed
Job name	out and discarded. This message remains on the display until the job being
	flushed is complete, which may require additional data to be sent from the
	host. This may require resubmitting the job to the printer.
Format Failed	A problem occurred during disk formatting. Printing may continue, but use of
Disk Locked	the disk is locked out.
	■ Try reformatting the disk again or replace it.
Fuser Fan	The printer’s fuser fan has failed.
Failure	■ Power OFF and ON the printer.
	■ If this message reappears, Power OFF the printer and contact your Customer
	Support Center.
Fuser Failure	The Fuser has failed; printing cannot resume.
Power Off/On	■ Power OFF and Power ON the printer.
	■ If the problem occurs again and you have just replaced the Fuser Cartridge,
	reseat it.
	■ If the problem occurs again and you have not replaced the maintenance kit,
	it may be time to do so.
	■ If the problem persists, contact your Customer Support Center.
Init Failed	This disk cannot be initialized because it has been locked via a PJL command.
Disk Locked	(It may be necessary to re-run the job without the lock command.)
Initializing...	This message appears for a few seconds while the printer is initializing.
	■ Wait.
Initializing…	The printer is initializing the flash memory.
Flash Memory	■ Wait.

Advanced Features and Troubleshooting Manual 91