Xerox N4525 manual Control Panel Menus, Tray Menu Items contd, Fuser Setting, Description

			Control Panel Menus
Tray Menu Items (cont'd.)
Special Media	The fusing system of the DocuPrint N4525 printer can be adjusted in two
Printing	ways to accommodate various types of special print media:
	■ The fusing temperature can be varied to match the requirements of the
	media.
	■ Brief printing delays can be set to occur at pre-defined points to allow the
	fuser temperature to recover properly for heavier weight media. The
	selected delay (15 seconds, 30 seconds, 45 seconds or 60 seconds) will
	occur before the printing begins, and then after every 15 pages while the
	printing is in progress.
	When the Config Fuser selection in the Tray Menu is set to On, media
	types are available as menu items (also in the Tray Menu). This enables the
	user to set fuser temperatures and delays appropriately to match the
	requirements of each media type.
	The following settings are available:
	Fuser Setting	Description	Examples of Usage
	Normal	Normal Temperature, No Delay	Ordinary Plain Paper
	Low	Low Temperature, No Delay	Transparency, Plastic label
	High	High Temperature, No Delay	Card Stock
	High - 15 sec.	High Temperature, 15 sec. Delay	Heavier Card Stock
	High - 30 sec.	High Temperature, 30 sec. Delay	Heavier Card Stock
	High - 45 sec.	High Temperature, 45 sec. Delay	Heavier Card Stock
	High - 60 sec.	High Temperature, 60 sec. Delay	Heavier Card Stock

For optimum results, temperature/delay settings should be based on the weight of the paper stock.

If using delays, send your output to either the Face-down Bin or Face-up Bin (not the Finisher).

Fuser temperatures and delays can be set for each paper type from the control panel. It may require some experimentation to obtain optimal prints.

Once the desired fuser settings have been stored for each media type, the procedure for printing on special media is as follows:

■Load the special media into a paper tray.

■Set Tray Type to match the special media loaded in the tray.

■From the driver properties screen, choose Select Paper, then set Type to match the type of special media loaded in the tray.

Advanced Features and Troubleshooting Manual 15