Xerox N4525 Control Panel Menus, Ethernet Menu Items contd, Address Res is set to static, 10/Half

Models: N4525

1 138
Download 138 pages 57.76 Kb
Page 43
Image 43
Address Res is set to static.)

 

Control Panel Menus

Ethernet Menu Items (cont'd.)

 

 

Sub Net Mask

Sets the four byte Sub Net Mask address. (This menu item only appears if IP

 

Address Res is set to static.)

 

Values:

 

xxx.xxx.xxx.xxx

 

where xxx = 000 to 255

 

Note: Once the control panel shows Sub Net Mask on the top line, use the

 

Value keys (labeled 3 or 7) to scroll to the desired value at the cursor

 

location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you

 

can change characters within the address rather than having to re-enter the

 

entire address.

 

 

Default Gateway

Sets the four byte Default Gateway address. (This menu item only appears if

 

IP Address Res is set to static.)

 

Values:

 

xxx.xxx.xxx.xxx

 

where xxx = 000 to 255

 

This item only appears if IP Address Res. is set to Static.

 

Note: Once the control panel shows Default Gateway on the top line,

 

use the Value keys (labeled 3 or 7) to scroll to the desired value at the cursor

 

location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you

 

can change characters within the address rather than having to re-enter the

 

entire address.

 

 

Port Timeout

Sets the time for determining when to end an incomplete print job and poll

 

the next port in the polling sequence. This menu item also causes an implicit

 

job end (such as Control D in PostScript or <ESC> E in PCL) and invokes the

 

emulation functions associated with this action (e.g., formfeed, reset, etc.).

 

Values (in seconds):

 

5 - 300 (default is 30)

 

The value changes by 1 each time you press either Value key (labeled 3 or

 

7). Hold down either key to scroll quickly through the values.

 

 

Speed

Sets the speed and half/full duplex mode of the 10/100BaseT Ethernet

 

interface. (This menu item does not appear when the 10Base2 Ethernet

 

interface is installed.)

 

Values:

 

Auto (default)

 

10/Half

 

10/Full

 

100/Half

 

100/Full

 

 

9100 Timeout

Sets the timeout for the AppSocket Port 9100 communications protocol.

 

Values:

On (default)

Off

Advanced Features and Troubleshooting Manual

27

Page 43
Image 43
Xerox N4525 manual Control Panel Menus, Ethernet Menu Items contd, Address Res is set to static, xxx.xxx.xxx.xxx, 10/Half