Xerox N4525 Control Panel Menus, System Menu Items contd, Face Down Bin default, Position 1 Front

Control Panel Menus

System Menu Items (cont'd.)

Output Timeout	Specifies whether the printer waits after a bin is filled or directs output to an
	alternate bin.
	Values:
	Off (printer waits after a bin is filled)
	On (default - printer directs output to an alternate bin)
Output Offset	Specifies whether output from jobs is offset in the Face-down Bin and
	Finisher Output Bin (if installed).
	Values:
	Off (default - output not offset)
	On (output offset)
	Note: Output cannot be offset in the optional Face-up Bin.
Output Dest	Sets the default paper output destination for PCL and PostScript jobs.
	Values:
	Face Down Bin (default)
	Face Up Bin (only shown if optional Face-up Bin is installed and
	enabled)
	Finisher Bin (only shown if optional Finisher is installed)
Staple Mode	Selects the default staple position. (Only appears when the Finisher is
	installed.)
	Values:
	Off (default - no stapling)
	Position 1 (Front)
	Position 2 (Rear)
	Dual (Two in middle)
	Refer to the User Guide for information on stapling positions.
Punch	Sets the default operation of the hole punch option. (Only appears when the
	Finisher is installed.)
	Values:
	Off (default)
	On
Print PS Errors	Specifies whether to print an error page whenever a PostScript error occurs.
	Values:
	Off (default)
	On
Power Saver	Specifies the number of minutes of inactivity before the printer enters a
	low-power state.
	Values: (in minutes)

Off (never enter Power Saver mode)

15

30

60(default)

20 DocuPrint N4525 Network Laser Printer