Pairing Bus Outs 111

Pairing Bus Outs

Bus outs 1 and 2 and bus outs 3 and 4 can be paired together for stereo signal process- ing. When paired, the master faders and ON buttons are linked for simultaneous con- trol.

Making Bus Out Pairs

1. Use the [SETUP] button to locate SETUP page 4, as shown below.

2.Use the cursor buttons to select bus pair 1/2 or 3/4, and then press the [ENTER] button.

The following dialog box appears.

BUS 1 –>2—Copy the settings of bus out 1 to bus out 2.

BUS 2 –>1—Copy the settings of bus out 2 to bus out 1.

RESET BOTH—Reset both bus outs to their initial settings.

3.Use the cursor buttons to select a pairing mode, and then press the [ENTER] button.

The highlighted switch and STEREO label show that the bus outs are now configured as a stereo pair.

Releasing Bus Out Pairs

1.On SETUP page 4, use the cursor buttons to select the paired bus switch, and then press the [ENTER] button.

The following dialog box appears.

2.Select OK, and then press the [ENTER] button.

The stereo pair is broken, and both bus outs operate independently.

01V—Owner’s Manual