Grouping Faders | 55 |
Grouping Faders
Input channel faders 1 through 16 can be grouped together in fader groups for
Making Fader Groups
1. Use the [SETUP] button to locate SETUP page 3, as shown below.
2.Use the up and down cursor buttons to select the fader groups, and the [SEL] buttons to add and remove faders to and from that group.
Channels cannot be in more than one group at a time.
Input channels 13/14, 15/16, and paired input channels 1 through 12 (“Pairing Input Channels” on page 52) are added and removed together.
Operate only one fader in a group at a time. If you attempt to adjust two or more faders in the same group, the fader motors may malfunction due to the increased load.
Enabling & Disabling Fader Groups
Fader groups can be enabled and disabled using the ENABLE switches. Disabling a group allows you to adjust faders without removing them from the group.
1.Use the up and down cursor buttons to select the fader group that you want to disable: A, B, or C.
2.Use the [ENTER] button, PARAMETER wheel, or
Fader group enabled
Fader group disabled