|
| REMOTE CONTROL FEATURES | |
|
| ||
| Clearing configurations |
|
| |
3 Press and hold CLEAR again for about 3 | |||
You can clear all changes made in each function set, such | seconds. | ||
“WAIT” appears in the display window. If clearing | |||
as learned functions, macros, renamed input area names | |||
was successful, “C;OK” appears in the display | |||
and setup remote control ID. | |||
window on the remote control. | |||
|
| ||
■Clearing function sets
1Set the operation mode selector to AMP or SOURCE and then press CLEAR by using a ballpoint pen or similar object.
“CLEAR” appears in the display window.
AMP
SOURCE
TV
CLEAR
or
AMP
SOURCE
TV
CLEAR
y
Once you have cleared a learned function for a button, the button reverts to the factory setting (or to the manufacturer setting, if you have set remote control codes).
Notes
•“L;ALL” and “FCTRY” may take about 30 seconds to complete.
•“C;NG” appears in the display window if clearing was unsuccessful. In this case start over from step 2.
•“ERROR” appears in the display window if you press a button not indicated in the respective step, or if you press more than one button simultaneously.
Note
If you do not complete each of the following steps within 30 seconds, the clearing mode will be automatically canceled. In this case, start over from step 1.
2Press k / n to select the clear mode.
L;CD (etc.) (L; Name of an input area)
Clears all learned functions in the respective input area. The name of a component is shown
| after a semicolon (;). Press an input selector |
| button to select the input area. |
L;AMP | Clears all learned functions for controlling the |
| amplifier functions of this unit. |
L;ALL | Clears all learned functions. |
M;ALL | Clears all programmed macros. |
RNAME | Clears all renamed source names. |
FCTRY | Clears all remote functions and returns the |
| remote to the factory settings. |
| PRESET/CH |
| ENTER |
| A/B/C/D/E |
OPERATION | ADVANCED |
|
|