CONNECTIONS

 

■ Connecting the banana plug

5 Hook the speaker terminal wrench onto the

(except U.K., Europe, Asia and Korea

WRENCH HOLDER on the rear panel of this

models)

unit when not in use.

The banana plug is a single-pole electrical connector

 

widely used to terminate speaker cables.

 

Banana plug

■Connecting to the SP2 speaker

terminals

Connect Zone 2 or Zone 3 speakers to these terminals (see page 130).

1Tighten the knob using the supplied speaker terminal wrench.

Speaker terminal wrench

1 Open the tab.

Red: positive (+)

Black: negative (–)

Red: positive (+)

Black: negative (–)

2 Insert the banana plug connector into the end of the corresponding terminal.

2Insert one bare wire into the hole on the terminal.

3Close the tab to secure the wire.

y

You can also use the banana plug with the SP2 speaker terminals. Open the tab and then insert one banana plug into the hole on the terminal. Do not close the tab after connecting the banana plug.

18 En