When using multiple YAMAHA receivers/amplifiers, you may be able to operate the other components simultaneously with the default code setting. In this case, set one of the alternative codes to operate this unit separately.
■Setting remote control AMP ID
1Set the operation mode selector to AMP or
SOURCE.
AMP |
| AMP |
SOURCE | or | SOURCE |
|
| |
TV |
| TV |
2Press and hold LEARN for about 3 seconds using a ballpoint pen or similar object and then press l / h repeatedly until “L;AMP” appears in the display window on the remote control.
PRESET/CH
LEARN
ENTER
A/B/C/D/E
Notes
•Be sure to press and hold LEARN for at least 3 seconds, otherwise the learning process will start.
•If you do not complete each of the following steps within 30 seconds, the setting mode will be automatically canceled. In this case, start over from step 1.
3Press ENTER.
The
PRESET/CH
ENTER
A/B/C/D/E
ADVANCED SETUP
4Press the numeric buttons to enter the
CLASSICAL LIVE/CLUB ENTERTAIN MOVIE
1 2 3 4
STEREO SUR. DECODE SELECT EXTD SUR.
5 6 7 8
90
Remote control AMP codes
Select one of the following codes to set the remote control AMP code for the input area you want to use.
AMP library |
| Remote | |
code |
| ||
Function | control AMP | ||
(remote control | |||
| ID | ||
setting) |
| ||
|
| ||
|
|
| |
2001 | To operate this unit using the | ID1 | |
(initial setting) | default code. | (initial setting) | |
|
|
| |
2002 | To operate this unit using an | ID2 | |
alternative code. | |||
|
| ||
|
|
|
Note
You need to set the corresponding remote control AMP ID | ADVANCED OPERATION | ||
(see page 135). | |||
| |||
|
| ||
5 Press ENTER to set the number. |
|
| |
“OK” appears in the display window if setting was |
| ||
successful. |
| ||
“NG” appears in the display window if the setting |
| ||
| |||
was unsuccessful. In this case, start over from step 1. |
| ||
PRESET/CH |
| ||
ENTER
A/B/C/D/E
6Press LEARN again to exit from the setup mode.
LEARN