Yamaha 376, RX-V2700, Stereo Receiver 132 En, using the remote control, ■Turning on or off Zone 2 and/or Zone, ■Selecting the input source of Zone 2 or Zone

USING MULTI-ZONE CONFIGURATION

y

•You must complete this step within 5 seconds while the selected zone flashes in the front panel display. Otherwise, the currently selected zone mode is automatically canceled. In this case, press ZONE CONTROLS again.

•The initial setting is ZONE2 when both Zone 2 and Zone 3 are turned on.

3Refer to “Selecting the input source of Zone 2 or Zone 3”, “Adjusting the volume level of Zone 2 or Zone 3”, “Adjusting the balance of the speaker level in Zone 2 or Zone 3” or “Adjusting the tonal quality of Zone 2 or Zone 3” on page 133 to perform further operations.

Remote control operations

1Set the operation mode selector to AMP and then press SELECT krepeatedly to select the zone you want to control.

“ZONE 2” or “ZONE 3” is displayed in the display window on the remote control.

AMP

SOURCE

SELECT

TV

■Turning on or off Zone 2 and/or Zone 3

using the remote control

POWER and STANDBY on the remote control work differently depending on the selected zone that appears in the display window on the remote control.

•When the main zone, Zone 2 or Zone 3 mode is selected (see page 132), you can turn on the main zone, Zone 2 or Zone 3 or set them to the standby mode individually.

•When the all mode is selected, pressing POWER turns on the main zone, Zone 2 and Zone 3 simultaneously and pressing STANDBY sets them to the standby mode simultaneously.

		POWER
Control mode	Display window	and
		STANDBY
Main zone	Name of the selected	Turns on the main
		zone only or sets it to
mode	input area
		the standby mode.
Zone 2 mode	“ZONE 2” or “2;name	Turns on Zone 2 or
	of the selected input	sets it to the standby
	area”	mode.
Zone 3 mode	“ZONE 3” or “3;name	Turns on Zone 3 or
	of the selected input	sets it to the standby
	area”	mode.
		POWER: turns on
		the main zone, Zone
All mode		2 and Zone 3.
	“ALL”	STANDBY: sets the
		main zone, Zone 2
		and Zone 3 to the
		standby mode.

or

2Refer to “Selecting the input source of Zone 2 or Zone 3”, “Adjusting the volume level of Zone 2 or Zone 3”, “Adjusting the balance of the speaker level in Zone 2 or Zone 3” or “Adjusting the tonal quality of Zone 2 or Zone 3” on page 133 to perform further operations.

3Press SELECT k / n to exit from the

Zone 2/Zone 3 mode.

Notes

•When the remote control is in the main zone mode, “MAIN” appears for a few seconds when POWER or STANDBY is pressed.

•“ALL” appears in the display window on the remote control only when SELECT n is pressed.

■Selecting the input source of Zone 2 or Zone 3

Rotate the INPUT selector on the front panel (or set the operation mode selector to AMP and then press one of the input selector buttons on the remote control) to select the input source of the selected zone.

If the remote control is used to select the input source, “2: name of the selected input area” or “3: name of the selected input area” is displayed in the display window on the remote control when Zone 2 or Zone 3 is selected respectively.

132 En