Preparing the remote control

■Installing batteries in the remote control

2

1

3

1Press the part and slide the battery compartment cover off.

2Insert the four supplied batteries (AAA, LR03) according to the polarity markings (+ and –) on the inside of the battery compartment.

3Slide the cover back until it snaps into place.

■Installing batteries in the Zone 2/Zone 3 remote control

13

2

1Take off the battery compartment cover.

2Insert the two supplied batteries (AAA, LR03) according to the polarity markings

(+ and –) on the inside of the battery compartment.

3Snap the battery compartment cover back into place.

CONTROLS AND FUNCTIONS

Notes

•Change all of the batteries if you notice the following conditions:

–the operation range of the remote control decreases.

–the TRANSMIT indicator does not flash or its light becomes dim.

•Do not use old batteries together with new ones.

•Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.

•We strongly recommend using alkaline batteries.

•If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

•Do not throw away batteries with general house waste; dispose of them correctly in accordance with your local regulations.

•If the remote control is without batteries for more than 2 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. When the memory is cleared, insert new batteries, set up the remote control code and program any acquired functions that may have been cleared.

■Using the remote control

The remote control transmits a directional infrared ray. Be sure to aim the remote control directly at the remote control sensor on this unit during operation.

Remote control sensor

Approximately 6 m (20 ft)

30

30

 

Notes

•Do not spill water or other liquids on the remote control.

•Do not drop the remote control.

•Do not leave or store the remote control in the following types of conditions:

–places of high humidity, such as near a bath

–places of high temperatures, such as near a heater or stove

–places of extremely low temperatures

–dusty places

INTRODUCTION

11 En