Znyx Networks bh5700 manual Zspconfig configure and start surviving partner

zspconfig

NAME

zspconfig - configure and start surviving partner

SYNOPSIS

zspconfig [-d <level>] [-p <directory_path>] [-u

<dhcp_interface>] [-c <dhclient.conf>] [-t <timeout>] [-s] [-v] -f <file>

DESCRIPTION

zspconfig is used to configure and start the Surviving Partner software. With the -foption a configuration file is provided that completely describes the network setup and desired behavior of all of the switches participating in the Surviving Partner. With the -uoption the interface on which to run dhclient to retrieve a configuration file must be provided. The configuration file format retrieved by a -uis identical to that supplied with -f. It is envisioned that the -foption is used for initial configuration, and all subordinate and replacement switches run zspconfig with the -uoption. The -voption prints the current version of zspconfig and performs no actions.

OPTIONS

-d <level> Set the debug level. The default debug level is 1. The higher the level, the more debugging output is produced. Debugging output is sent to the console.

-p <directory_path>

Set the directory path for where zspconfig places the scripts it generates. The default location is /etc/rcZ.d/surviving_partner.

-u < dhcp_interface>

Come up as an unconfigured slave. Use the specified <dhcp_interface> to retrieve the configuration. User confirmation is not required unless the –s option is also used.

-c <dhclient.conf>

Use file <dhclient.conf> as the configuration file to dhclient when retrieving configuration information. If –c is not used, a default configuration file is created and used. Only valid with the –u option.

Ethernet Switch Blade User's Guide release 3.2.2j page 246