Znyx Networks bh5700 manual Zl3d zhp1 zhp2 zhp3

produces more output. Four (4) is currently the maximum output level.

<iface…> The network interfaces on which zl3d should operate. These network interfaces must first be created by zconfig. zl3d does not operate with standard network interface cards. It only works on switch network interfaces created by zconfig. It uses the same syntax as zconfig.

OPERATIONS

zl3d manages the host route and network route tables located in the switch. Based on a trigger condition, zl3d reads the Linux FIB table and the Linux route cache. Each table entry is filtered by zl3d according to the following:

•If an entry from the route cache is not a broadcast address or a local address, and zl3d is able to resolve the MAC address of the destination, then zl3d inserts the entry into the switch host route table.

•If an entry in the Linux FIB table is a host entry and zl3d is able to resolve the MAC address of the destination host, then the entry is inserted into the switch host route table. If an entry from the FIB table is a gateway entry, is not local, and zl3d is able to resolve the MAC address of the gateway, then the entry is inserted into the switch network route table.

EXAMPLES

Normally, zl3d is run as a background task that continues throughout the life of the Layer 3 network.

In the following example, for the three interfaces specified, zl3d continuously monitors the Linux FIB and route cache tables looking for updates every three seconds. Entries in the switch host route table are checked for activity every 15 seconds and aged accordingly.

zl3d zhp1 zhp2 zhp3

SEE ALSO

zconfig

Ethernet Switch Blade User's Guide release 3.2.2j page 305