Znyx Networks bh5700 manual Lower Case ‘m’ the time is specified in milliseconds

other words there is a unique vrid to ifname associated with the –i option.

-s Toggle preemption mode (Enabled by default). Preemption means that a Master switch will go to Backup if a current Backup has higher priority.

-M Become MASTER when priority is equal. Be sure it is only set on one host or the switches will oscillate. Must set –B option on other hosts (requires preemption mode ! -s)

-B	Become BACKUP when priority is equal. See -M option
-S	<script>	script to be called when state change occurs.

-a <auth> (not yet implemented) set the authentication type auth=(nonepass/hexkeyah/hexkey) hexkey=0x[0-9a-fA-F]+

-p <prio> Set the priority of this host in the virtual server (default is 100)

-f <piddir> specify the directory where the pid file is stored (default is /var/run)

-c <conf> Configuration read from conf file (required when managing multiple Virtual Routers). The contents of the conf file are lines of command line options. Each line represents a Virtual Router. Parameters given on the command line apply to all Virtual Routers defined by the conf file. So for example, if the command line reads:

vrrpd –d 50 –c vrrpd.conf

And the vrrpd.conf file contains: -v 1 –i zhp0 –I zhp3 10.0.0.42 -v 2 –i zhp1 –I zhp3 11.0.0.42

vrrpd would be started controlling two Virtual Routers; one for

10.0.0.42and the other for 11.0.0.42. They would both get a –d

50 option.

-d <delay> Set the advertisement interval. Default is 1 second.

By default		time is specified in seconds. If the delay		value ends
in	a lower	case ‘m’ the time is specified in milliseconds. The
millisecond specification results in a proprietary use				of the
VRRP Adver		Int field.
-m	<address>		Change the virtual MAC address from

00:00:5E:00:01:<vid> to the provided addr. The addr should be input as 6 two digit hex numbers that are colon delimited with no

Ethernet Switch Blade User's Guide release 3.2.2j page 270