Znyx Networks bh5700 manual Options

	displayed by query, but must be set at initialization. After setting
	the healthy state, the query will return the backup state.
backup	Used to reflect the backup state of vrrpd
master	Used to reflect the master state of vrrpd

The priority value is a value between 0 and 255. In the HA suite, the value is set to 254 minus the number of ports that are link down.

The state or priority value for the local or peer can be displayed with the query command. The following will query the state of the peer switch:

zpeer peer state query

The output from the above command during the boot process would be “unhealthy”

The -aoption can be used to display a complete listing of all state and priority information and internal information that can be used for debugging. Here is example output from the -aoption.

priority	Local/Write	Peer/Read
	203	231
state	master	backup
data	2cb	2e7
position bytebit	28	20
status	50(ACK)	0()

The priority and state rows are the same values returned by the query command. The information in the data, position and status rows are internal debugging information that is useful to support engineers when diagnosing problems in the field.

The -roption should not be used while HA is running. It can cause loss of coordination between the two switch planes. The -roption will reset all internal communication values, and possibly require the peer to be reset also.

OPTIONS

-d set debug level to <level>

-a Display complete status of zpeer

-r Reset all values in the zpeer communication. Can cause loss of communication with the peer requiring the peer to

Ethernet Switch Blade User's Guide release 3.2.2j page 317