Znyx Networks bh5700 manual Upgrading the Switch Driver, Upgrading or Adding Files

the limit of free space available on a default system, so you may need to clear some space prior to downloading the new OpenArchitect image to the switch.

CAUTION: Do not remove the existing copy of /usr/sbin/gated (as suggested in Step 5, below) until you have, in fact, determined that an OpenArchitect upgrade version is available for downloading.

5.One of the easiest ways to create free space is to remove /usr/sbin/gated, as the application will be replaced during the update procedure. Once you have enough free space, proceed.

6.From the switch console, ftp the new OpenArchitect (rdr) image from the local system to your switch.

7.The switch has two flash available: Device 1 and device 2. Use the zflash command to write the new OpenArchitect image into the first flash device.

IMPORTANT: Make sure that Surviving Partner is not running before using zflash. The delays incurred while zflash writes the flash can cause the Surviving Partner daemons to think there is a failure, resulting in link oscillation.

zflash -d 1 <image_file>

The image file will be something named similar to the following,

zflash -d 1 rdr6000.zImage.initrd

Upgrading or Adding Files

Follow the procedure below to upgrade or add a new file to the switch. Place the file you are adding or upgrading into the appropriate location in the file system. Save the file in the overlay directory area on the application flash by running zsync.

zsync

After running zsync, the file is saved to the flash for future reboots.

Excluding Saving Files to Flash

Specific files or directories can be excluded from saving to flash by zsync by including an entry in /etc/exclude. Likewise, existing entries in /etc/exclude such as /tmp can be removed in order to save those files to flash with zsync.

Upgrading the Switch Driver

The switch driver upgrade process is the same as a file upgrade. However, more caution should be taken since the driver module is likely to be the method by which you are logging into the system. If the switch driver has a problem, you will need to have a console cable to recover. To upgrade a switch driver, replace the file /lib/modules/if_zxe.o, run zsync and reboot.

Ethernet Switch Blade User's Guide release 3.2.2j page 143