Znyx Networks bh5700 manual Zrl0=ip sourceaddress, ip destinationaddress Is the same as

ports.

teardown Removes the trunk interface, making the ports which were part of the trunk available for configuration in other trunks or VLANs.

all

mac [ source_address destination_address ] ip [ source_address destination_address ] port [ source_port destination_port ]

Further specifies the rules for selecting which port in the trunk a packet should be transmitted out of. A comma delimited list is valid to specify more than one criterion. Specifying a particular option only uses that layer’s source

and destination information. The default is all, which combines all criteria for determining the transmit port of the trunk. Specifying both source and destination for a given layer is the same as specifying that layer itself, i.e,

zrl0=ip source_address, ip destination_address

is the same as,

zrl0=ip

NOTE: The Ethernet Switch Blade supports destination_address and/or source_address for MAC and IP. It cannot combine MAC and IP settings, nor does it support port settings.

Examples of trunk interface statements:

This statement creates a trunk containing three ports:

zrl5 = zre11,zre15,zre17;

The following statement specifies that packets will be sent out over this trunk using the exclusive OR of the last four bits of their MAC source and destination addresses to select the port:

zrl5 = mac source_address, mac destination_address;

The teardown statement uses a colon instead of an equals sign:

zrl5: teardown

Network Interface Statements

Ethernet Switch Blade User's Guide release 3.2.2j page 201