ZyXEL Communications USG 2000 manual 211

Chapter 9 Dashboard

Table 21 Dashboard (continued)

LABEL	DESCRIPTION
	The following front and rear panel labels display when you hover your
	cursor over a connected interface or slot.
Name	This field displays the name of each interface.
Slot	This field displays the name of each extension slot. An installed SEM
	(Security Extension Module) card enhances the ZyWALL’s VPN and/or
	UTM performance. See the SEM User’s Guide for how to install an SEM.
Device	This field displays the name of the device connected to the extension slot
	(or none if no device is detected).
Status	This field displays the current status of each interface or device installed
	in a slot. The possible values depend on what type of interface it is.
	For Ethernet interfaces:
	Inactive - The Ethernet interface is disabled.
	Down - The Ethernet interface is enabled but not connected.
	Speed / Duplex - The Ethernet interface is enabled and connected.
	This field displays the port speed and duplex setting (Full or Half).
	Port Group Inactive - The Ethernet interface does not have any
	physical ports associated with it.
	Port Group Up - The Ethernet interface is part of a port group and is
	connected.
	Port Group Down - The Ethernet interface is part of a port group and is
	not connected.
	For cellular (3G) interfaces, see Section 13.5 on page 299 for the status
	that can appear.
	For the auxiliary interface:
	Inactive - The auxiliary interface is disabled.
	Connected - The auxiliary interface is enabled and connected.
	Disconnected - The auxiliary interface is not connected.
HA Status	This field displays the status of the interface in the virtual router.
	Active - This interface is the master interface in the virtual router.
	Stand-By- This interface is a backup interface in the virtual router.
	Fault - This VRRP group is not functioning in the virtual router right now.
	For example, this might happen if the interface is down.
	n/a - Device HA is not active on the interface.
Zone	This field displays the zone to which the interface is currently assigned.
IP Address/	This field displays the current IP address and subnet mask assigned to
Mask	the interface. If the interface is a member of an active virtual router, this
	field displays the IP address it is currently using. This is either the static
	IP address of the interface (if it is the master) or the management IP
	address (if it is a backup).

	211
ZyWALL USG 2000 User’s Guide