Chapter 39 Device HA

39.2 Device HA General

The Configuration > Device HA General screen lets you enable or disable device HA, and displays which device HA mode the ZyWALL is set to use along with a summary of the monitored interfaces.

Figure 450 Configuration > Device HA > General

The following table describes the labels in this screen.

Table 178 Configuration > Device HA > General

LABEL

DESCRIPTION

Enable Device

Turn the ZyWALL’s device HA feature on or off.

HA

 

 

Note: It is not recommended to use STP (Spanning Tree Protocol)

 

with device HA.

 

 

Device HA

This displays whether the ZyWALL is currently set to use active-passive

Mode

mode device HA or legacy mode device HA. Active-passive mode is

 

recommended for general device failover deployments. Only use legacy

 

mode if you need a more complex relationship between the master and

 

backup ZyWALLs, such as active-active or using different ZyWALLs as

 

the master for individual interfaces.

 

The master and its backups must all use the same device HA mode.

 

Click the link to go to the screen where you can configure the ZyWALL to

 

use the device HA mode that it is not currently using.

 

 

Monitored

This table shows the status of the interfaces that you selected for

Interface

monitoring in the other device HA screens.

Summary

 

 

 

#

This is the entry’s index number in the list.

 

 

Interface

These are the names of the interfaces that are monitored by device HA.

 

 

Virtual Router

This is the interface’s IP address and subnet mask. Whichever ZyWALL is

IP / Netmask

the master uses this virtual router IP address and subnet mask.

 

 

Management

This field displays the interface’s management IP address and subnet

IP / Netmask

mask. You can use this IP address and subnet mask to access the

 

ZyWALL whether it is in master or backup mode.

 

 

Link Status

This tells whether the monitored interface’s connection is down or up.

 

 

 

669

ZyWALL USG 2000 User’s Guide