14
6 troubleshooting
WARNING: Unplug trimmer/edger from power source before servicing.
Severe injury or death could occur from fire, electrical shock, or rotating line.
Note: For additional help, visit our technical ser vice web site at www.desatech.com.
OBSERVED FAULT | POSSIBLE CAUSE | REMEDY | ||
|
|
|
|
|
Motor does not run when you turn trig- | 1. | Extension cord connection is loose | 1. | Check cord connection at electri- |
ger switch on |
|
|
| cal outlet and at rear of trimmer/ |
|
|
|
| edger |
|
|
|
|
|
Line does not feed when you tap the | 1. | All line has been used on spool | 1. | Install new line on spool, following |
line advance button |
|
|
| steps under Replacing Trimmer/ |
|
|
|
| Edger Line, page 8 |
| 2. | Line has retracted into spool | 2. | Remove spool and pull line out, |
|
|
|
| then replace spool |
3.Line is caught or tangled on spool and will not feed
3.Remove spool, loosen and un- tangle line, then replace spool
Replacement Spool
Part Number | Description |
RS65B | Replacement Spool |
| with Line |
WARNING: Use of
Technical Service
You may have further questions about assembling, operating, or maintain- ing this trimmer/edger. If so, you can visit our Technical Service web site at www.desatech.com or contact our Technical Service Department at
DESA Specialty Products™
ATTN: Technical Service Specialty Products
P.O. Box 90004
Bowling Green, KY
When contacting DESA Specialty Prod- ucts™, have ready
•Your Name
•Your Address
•Your Phone Number
•Model Number of Product
•Date of Purchase (include copy of receipt for written requests)