Bypass Mode: Allows water to
Allowing the unit to run for more than
two minutes without the gun trigger pulled could cause overheating and damage to the pump.
Chemical Injection System: Mixes cleaners or cleaning solvents with the water to improve cleaning effectiveness.
Water Supply: All pressure washers must have a source of water. The minimum requirements for a water supply are 20 PSI and 5 gallons per minute.
Thermal Relief Valve: When the temperature inside the pump rises too high the valve will open and release a gush of water in an effort to lower the temperature inside
the pump. The valve will then close.
PRESSURE WASHER OPERATING FEATURES
PRESSURE ADJUSTMENTS
The pressure setting is preset at the factory to achieve optimum pressure and cleaning. If you need to lower the pressure, it can be accomplished by these methods.
1.Back away from the surface to be cleaned. The further away you are, the less the pressure will be on the surface to be cleaned.
2.Change to the 40º nozzle - this nozzle delivers a less powerful stream of water and a wider spray pattern.
DO NOT attempt to increase pump pressure. A higher pressure setting
than the factory set pressure may damage pump.
TO USE GATLING™ SPRAY WAND
The nozzles for the spray wand are stored in the gatling spray wand. See chart to choose the correct nozzle for the job to be performed.
CHANGING NOZZLES ON SPRAY WAND
Risk of fluid injection. Do not
direct discharge stream toward persons, unprotected skin, eyes or any pets or animals. Serious injury will occur.
Risk of fluid injection. Do Not
attempt to change nozzles while pressure washer is running. Turn engine off before changing nozzles.
1.Press turret release button to release turret.
2.Rotate turret to chosen nozzle.
3.Push turret onto nozzle and lock into place.
11- ENG | A20118 |