Installation Instructions, Anti-tumble measures

INSTALLATION INSTRUCTIONS

Installation

■No stand is provided with this product. When installing the monitor, use the optional Desk-top Stand (CMPAD05), Wall Mount Unit (horizontal-mount CMPAK04 or CMPAK05, vertical/horizontal-mount CMPAK14), or Ceiling Mount Unit (CMPAT04).

The Desk-top Stand has been used for the illustrations in this manual.

	• Use one of the special mount units to install this product. A mount of insufficient
WARNING	strength or inadequate design can cause overturning or dropping and result in fire,
	electrical shock or injury. Please note that our company assumes absolutely no
	responsibility for personal injuries or property damage caused by use of other
	mount units or improper installation.
	• Installation of the wall mount unit and ceiling mount unit can be dangerous, so do not
CAUTIONS	attempt this work yourself. Ask your dealer to provide the name of a qualified installer.
	• In order to prevent an internal temperature increase, maintain a space of 10cm (4
	inches : For a desktop set-up) or more between the sides and other objects such as
	walls, etc., so that the ventilation holes are not blocked.*
Anti-tumble measures
CAUTIONS	• Have this unit mounted in a stable place. Take measures to prevent it from
	tumbling down to avoid possible physical injury.
Securing to a wall or pillar		10cm (4 inches) or more*

1)Using a commercially available cord, chain and clamp, secure the set to a firm wall or		Clamp

pillar.		Cord

		or
		chain
Securing desktop
1)Using wood screws (two), fasten the set to the clamping screw holes on the rear of the
stand as shown.
2)Using commercially available wood screws, secure the set firmly in position.		Wood screw
		Two places

ENGLISH

Using the optional vertical-mount unit (CMPAK14)

Using the optional wall-mount unit (CMPAK14) allows set to mount on wall surfaces as shown at right.

1)Make at least four sets of commercial anchor bolts and screws available to meet various kinds of walls to mount on.

2)Read the instructions supplied with the wall-mount unit carefully to optimally locate the plasma display on a wall surface.

3)Prepare the wall surface for anchoring and drilling as needed, as shown in the sketches.

•Make sure that an adequate wall surface strength and a screw holding strength are available.

Horizontal mounting

Upper left vertical mounting

■ Upper left vertical mounting

Plasma display outline

■ Horizontal mounting

8Ω 8W

Plasma display outline

8Ω 8W

Driving anchor bolts into a wall surface

Wall surface

Anchor bolt

Hold to 25 mm (1 inch)

or below.

CAUTION

•The mounted unit should have the indicating lamp at its bottom. Otherwise, an elevated internal temperature rise could cause the unit to fail or fire.