Hitachi 42HDW10 user manual Handling the Remote Controller, Loading Batteries

ENGLISH

INSTALLATION INSTRUCTIONS (continued)

Handling the Remote Controller

Loading Batteries

1)Open the battery cover.

•Slide the battery cover towards the arrow mark while pressing it.

2)Load batteries.

• Load two Size AA batteries included observing the correct polarities.

3)Close the battery cover.

•Slide back the battery cover towards the arrow mark.

Handling the Remote Controller

•Use the remote controller within about 5 m from front of the unit’s remote-control sensor and within 30 degrees on both

sides.

With in 30	With in 30
degrees	degrees
About 3m	About 3m

About 5m

	• Do not use new and old batteries together. The batteries could
	explode or leak, resulting in fires, physical injury, or stains.
CAUTIONS	• When loading batteries, observe their correct polarities as marked on
	the product. If loaded in the wrong direction, the batteries could
	explode or leak, resulting in fires, physical injury, or stains.
	• Do not drop or impact the remote controller.
	• Do not splash the remote controller with water or put it on a wet
	object to avoid possible failures.
	• Before leaving the remote controller out of use for an extended
TIPS	period of time, remove the batteries from it.
	• If the remote controller begins to lack responsiveness, replace the
	batteries.
	• Strong light such as direct sunlight impinging on the photoreceptor
	of the remote control can cause operational failure. Position this unit
	to avoid direct contact with such light.

8