Turning off the power
RGB input indicator | Power indicator |
#
$
%
POWER
INPUT
VIDEO RGB
AUTO
SETUPMENU
ENTER
FREEZE | SHUTTER |
STD
VOLUMED.ZOOM
INDEX
WINDOW
PROJECTOR
NOTE:
BYou can also turn off the power by pressing the POWER button twice or by holding down it for at least 0.5 seconds.
BWhen the projector is in standby mode (the power indicator on the projector is illuminated red), the projector will still draw a maximum 3 W of power, even when the cooling fan has stopped.
Power indicator
Power indicator status | Projector status | |||
Red | Illuminated | The projector is in standby mode and image projection |
| |
is possible by pressing the POWER button. | ||||
|
| |||
Basic Operation
#Press the POWER button.
B“POWER OFF” is displayed on thePOWER OFF
| The projector is preparing for projection after the |
Flashing | power is turned on while the power indicator is |
screen.
OK CANCEL
Green | illuminated red. (After a short period, a picture will be | |
|
| projected.) |
| Illuminated | A picture is being projected. |
$Select “OK” using the I and H buttons and then press the ENTER button.
BThe lamp unit will switch off and the picture will stop being projected. (The power indicator on the projector will illuminate orange.)
%Press the MAIN POWER switch to turn off the power after the power indicator on the
projector illuminates red.
BDo not cut power to the projector in any way while the cooling fan is still operating. Be careful not to switch off the MAIN POWER switch of the projector or unplug the power cord from the electrical outlet.
| Illuminated | The lamp is cooling down after the power is turned | |
| off. (The cooling fan is operating.) | ||
|
| ||
|
|
| |
Orange | The projector is preparing for projection after the | ||
power is turned on while the power indicator is | |||
| Flashing | ||
| illuminated orange. (After a short period, a picture | ||
|
| ||
|
| will be projected.) | |
RGB INPUT indicator |
| ||
|
| ||
RGB INPUT indicator status | Projector status | ||
Illuminated during | A signal is being input to either the RGB1 IN or | ||
standby mode | RGB2 IN connector. | ||
|
| ||
Illuminated during | A signal is being input to the connector selected | ||
projection | using the input select buttons. | ||
|
|
| |