NOTE:
BThis projector is equipped with an aspect ratio selection function. However, if a mode which does not match the aspect ratio of the input signal is selected, it may affect the quality of viewing of the original picture. Keep this in mind when selecting the aspect ratio.
BIf using this projector in places such as cafes or hotels with the aim of displaying programs for viewing for a commercial purpose or for public presentation, note that if the aspect ratio (16:9) selection function is used to change the aspect ratio of the screen picture, you may be infringing the rights of the original copyright owner for that program under copyright protection laws.
BIf a normal (4:3) picture which was not originally intended for wide- screen viewing is projected onto a wide screen, distortion may occur around the edges of the picture so that part of the picture is no longer visible. Such programs should be viewed in 4:3 mode to give proper consideration to the aims and intentions of the original program’s creator.
RESIZING
This should normally be set to “ON”. (This setting is only for signals which have lower resolutions than the LCD panels. Refer to page 58 for details.)
ON
The pixel resolution of the input signal is converted to the same resolution as the LCD panels before being projected. For signals with lower resolutions, gaps in the pixels are automatically interpolated into the picture before it is projected. This may sometimes cause problems with the quality of the picture.
OFF
The picture signal is projected at its original resolution, with no pixel conversion. The projected picture will be smaller than normal, so adjust the zoom setting or move the projector forwards or backwards to adjust the picture size if necessary. If set to “OFF”, some features, such as D.ZOOM (digital zoom), keystone distortion correction or INDEX WINDOW will not function.
FRAME LOCK
If the picture’s condition is bad while a RGB moving picture signal is projected, set the FRAME LOCK to “ON”. Refer to page 58 on compatible RGB signals.
Changing the display language
Use the F and G buttons on the projector or remote control unit to select a language, then press the ENTER button to accept the setting.
LANGUAGE | ENGLISH |
| Indicates the language which is |
| |||
ENGLISH |
|
| currently set |
DEUTSCH |
|
|
|
FRANÇAIS |
|
|
|
ESPAÑOL |
|
|
|
ITALIANO |
|
|
|
SELECT 
ENTER 
RETRN
Adjustments and settings