Correcting keystone distortion and automatic positioning (AUTO SET UP)
This projector detects its degree of tilt and the input signal. Keystone distortion and the position of the image can then be corrected automatically in accordance with the input signal.
Press the AUTO SETUP button.
POWER | INPUT | (When the projected image has caused keystone distortion) | ||
VIDEO | RGB | |||
|
| |||
AUTO | MENU | Screen |
| |
SETUP |
| |||
ENTER |
|
|
| |
|
| Projected |
| |
FREEZE | SHUTTER | image |
| |
STD |
| BAutomatic positioning | [ | |
VOLUME | D.ZOOM | |||
INDEX |
| will be carried out. |
| |
WINDOW |
|
|
| |
PROJECTOR
Projector control panel
If you press the AUTO SETUP button, the items given in the table below will be set automatically in addition to keystone distortion being corrected. The setting details change according to the signal which is being input.
Turning off the picture and sound momentarily (SHUTTER)
The shutter function can be used to momentarily turn off the picture and sound from the projector when the projector is not being used for short periods of time, such as during breaks in meetings or when carrying out preparation. The projector uses less power in shutter mode than it does in normal projection mode.
POWER | INPUT | Press the SHUTTER button. | |
| BThe picture and sound will be turned off. | ||
VIDEO | RGB | ||
BPress any button on either the projector or | |||
|
| ||
AUTO | MENU | remote control unit to return to normal operating | |
SETUP | mode. | ||
| |||
|
| ||
ENTER |
|
| |
|
| NOTE: | |
FREEZE | SHUTTER | B“SHUTTER” on the MAIN MENU is the same | |
|
| ||
|
| function. | |
STD |
|
| |
VOLUME | D.ZOOM |
| |
INDEX |
|
| |
WINDOW |
|
|
PROJECTOR
Pausing a picture (FREEZE)
Useful functions
Input signal | Contents set up automatically | Page |
| POSITION, DOT CLOCK, CLOCK PHASE |
|
RGB signals | (If the dot clock frequency is 100 MHz or higher, the DOT | 38 |
CLOCK and CLOCK PHASE will not be set automatically.) |
| |
|
|
|
| AUTO RGB IN | 42 |
|
|
|
YPBPR signals | AUTO RGB IN | 42 |
|
|
|
NOTE:
B If the edges of the projected picture are indistinct, or if a dark picture is being |
projected, the automatic setup processing may stop automatically before it is |
complete. If this happens, project a different picture and then press the AUTO |
SETUP button once more, or make the above adjustments manually. |
B If you would like to make further adjustments to the picture, use the menu |
POWER
INPUT
VIDEO RGB
AUTO
SETUPMENU
ENTER
FREEZE | SHUTTER |
STD
VOLUMED.ZOOM
INDEX
WINDOW
Press the FREEZE button.
Still picture
BThe picture being projected will be paused.
BPress the FREEZE button again to cancel the still picture.
commands which are listed on page 30 and subsequent pages. |
B Set “AUTO KEYSTN” in the OPTION1 menu to “OFF” to prevent any deterioration |
of the picture as a result of keystone correction. (Refer to page 42.) |
PROJECTOR