Panasonic WJ-FS616C manual Freezing Single Spot Playback

2.Select the VCR playback mode (indicator on) by press- ing the [VCR/CAM] button.

VCR

CAM

3.In this condition, select the images to be displayed on the monitor screen followed the procedure shown below.

Notes:

•This unit does not reproduce a clear image in reverse playback.

•The playback image may be skewed (horizontally distorted) in the upper portion of the monitor screen depending on the selected playback mode.

•The indicator in the VCR/CAM button blinks when no signal is input to the PLAY IN connector on the rear of the multiplexer.

The indicator also blinks if the codes (camera ID numbers, etc.) recorded on the videotape track have not been read for some reason. In this case, the playback image is displayed simply by tracing along the tape. Skipping instructions or other selections are ignored.

•The looped through VCR output may appear on the monitor while playing back a tape in forward or reverse search.

•The image or title may become unstable because of the recording field rate.

•Depending on the condition of the VCR’s video heads, the images of another channel may appear on the monitor.

If this occurs frequently, adjust the tracking and slow tracking of the VCR.

•The size of images displayed on the multiscreen is smaller than in single image format, which makes the titles hard to read. Select single image (spot) to make titles easier to read.

•Playback in linear mode (L12H, L18H, or L24H) may produce noise or the image of another channel in any recorded mode. Play back the tape in normal (real time mode) or time lapse mode.

•Select FS10 in the SETUP MENU to play back a recorded tape with the WJ-FS10. (See page 42)

It is recommended to play back on the 16-segment screen and select the desired camera channel from the images displayed, because a tape recorded with the WJ-FS10 multiplexer is not compatible with one recorded on the WJ-FS616C (the camera dis- play channels for recording and playback differ).

While the [VCR/CAM] button is on, the VCR playback images on the monitor can be controlled followed the procedure described below.

Confirm that the VCR is playing back the recorded videotape.

●Single Spot (Playback)

1.Select an image to be displayed on the monitor by pressing a [1 – 16] button.

The indicator in the selected button lights and the play- back image corresponding to the button appears on the monitor screen.

2

Note: While playing back a videotape recorded in quad images, the corresponding 4-segment image is dis- played, if the selected number is recorded as part of the quad image.

For instance, if #5 is selected, the quad image of “5-6-7-8” is displayed.

2.To select another image, press a [1 – 16] button corre- sponding to the image.

The selected image appears on the monitor screen. The indicator in the button previously selected turns off and the indicator in the button currently selected lights.

●Freezing Single Spot (Playback)

While the image on the monitor screen is displayed in sin- gle spot mode, the image can be frozen followed the pro- cedure below.

1.Select an image to be frozen on the monitor by press- ing a [1 – 16] button.

The indicator in the selected button lights and the play- back image corresponding to the button appears on the monitor screen.

2.Press the [STILL] button to display the freeze image on the monitor.

The indicator in the STILL button lights and the indicator in the pressed CAMERA button starts to blink.

3.To cancel this mode, press the [STILL] button to return to the image previously shown.

The indicator in the button goes off.

Note: The VCR does not enter pause mode while the freeze image is displayed on the monitor screen.

52