6Function button Function, @8Power Cord

!6Function button (FUNCTION)

This button is used to display the camera images with a VCR playback image on the multiscreen monitor.

While displaying the setup menu on the monitor, press- ing this button will select the next page of the setup menu.

!7Auto/Increment button (AUTO/+ )

This button is used to activate the auto panning function if the camera is equipped with the specific future.

While displaying the setup menu on the monitor, press- ing this button will select the parameter forwardly in the setup menu.

!8Home/Decrement button (HOME/–)

This button is used to return to the home position of the camera.

While displaying the setup menu on the monitor, press- ing this button will select the parameter reversely in the setup menu.

!9Alternate button (ALT)

Press this button to have the other 8 buttons switch to their alternate functions. These buttons are identified by special labeling - - text or a symbol in a rounded corner rectangular. For example, while the indicator (green) of the ALT button is lit, pressing the STILL but- ton controls the VCR fast forward function.

@0Multiscreen Selection button (MULTISCREEN

SELECT)

This button is used to select the multiscreen pattern to be displayed on the multiscreen monitor while monitor- ing the camera images or VCR playback images.

Pressing this button will toggle the screen pattern as follows:

Camera Images:

4→ 7→ 9→ 10→ 13→ 16→ 4 screen segments

VCR Playback Images:

4→ 9→ 16→ 4 screen segments

@1Electronic Zoom button (EL-ZOOM)

This button is used to zoom the image currently dis- played on the multiscreen monitor.

Note: The above operation is not valid unless multi- screen output is selected by pressing the [F1] but- ton.

@2Alarm Reset button (RESET)

This button is used to cancel an activated alarm.

Press this button, while the alarm function is activated, to reset the alarm and return the system to the condition before the alarm function was activated.

When more than one multiplexer are connected in a daisy chain, pressing the ALT button and then this but- ton resets all alarm inputs at once.

@3Data ports (DATA, IN/OUT)

Exchanges control data with the video multiplexer in a system.

@4Termination switch (TERM., ON/OFF)

This switch enables termination of the controller’s data port.

When combined with the video multiplexer, set this switch to the “ON” position.

@5Controller Unit Number switch (CONTROLLER UNIT NO. 1-8)

This switch is used to identify the unit number of the System Controller.

When combined with the video Multiplexer, set this switch to the “0” position.

@6Mode Selection switch (MODE)

These switches are used to set the mode of the system controller connected to the video multiplexer.

When combined with the WJ-FS616C video multiplexer, set as shown below.

MODE

OFF

@7Controller On/Off switch (CONTROLLER ON/OFF)

This switch is used to turn the system controller power on or off.