Panasonic WJ-FS616C Function Operations with WV-CU550C, Controlling the Video Input and Monitors

FUNCTION OPERATIONS (WITH WV-CU550C)

When operating the video multiplexer with the WV-CU550C system controller, the following buttons and keys of the sys- tem controller correspond with those of the video multiplex- er.

Controlling the Video Input and Monitors

UP

LEFT HOME/SET RIGHT

DOWN

Direction Button

CAMERA/PRESET POSITION

1	2	3	4
5	6	7	8
9	10	11	12
13	14	15	16

UP

LEFT RIGHT

DOWN

Joystick Controller

1 2 3

4 5 6

7 8 9

MON 0 CAM

To select a monitor and camera, follow the procedure shown below.

1.Turn on the power of the system controller by pressing the Controller On/Off Switch located on the rear of the system controller to the ON position.

The following displays appear on the LCD display.

Unit Number	Camera Number	Playback, PRE-POSI,
	(“Mlt”or “Seq”)	STILL, camsetup

U01	C01
_MLT ∗ SPOT _ SEQ			_VCR
F1	F2	F3	F4

Select the mode by pressing the Function buttons. The buttons operate as shown below.

UNIT/ESC SET

Camera Selection Buttons Numeric Key + Set Key

While the indicator of the [ALT] button is on, control of the VCR with the buttons shown below is enabled.

/		:	Rewind	FUNCTION
		:	Pause	PRE-POSI
	/	:	Fast Forward	STILL
		:	Reverse Play	CAMERA SET ON A
		:	Stop	EL-ZOOM
		:	Play	CAMERA SET OFF B
		:	T/L mode	C
		:	T/L mode	SET UP D
		:	Record	MULTISCREEN SELECT

Refer to the supplied panel templates for the other but- tons.

Note: When controlling the multiplexer with the WV- CU550C, it is recommended to set the LOCK switch on the WJ-FS616C to the ON position to prevent false operation.

F1: Same operation as MULTISCREEN button

F2: Same operation as SPOT button

F3: Same operation as SEQUENCE button

F4: Same operation as VCR/CAM button

_ Mode OFF

✽MODE ON

2.Set the LCD display to ✽SPOT or ✽MLT by pressing the [F2] or [F1] button on the controller.

The indicator on the LCD display indicates the selected monitor.

3.Select the desired camera number by pressing the Numeric keys, then press the [CAM(SET)] key.

The selected camera image is displayed in single spot on the selected monitor screen.

1 2 3

4 5 6

7 8 9

MON 0 CAM

UNIT/ESC SET

Note: Proceed as described for Controlling the Video Input and Monitors on page 48 to 55.

71