Panasonic WV-CU360C manual Controller Setup Procedures PSData, Prior to Setup

CONTROLLER SETUP PROCEDURES (PS•Data)

To display the setup menus for the WV-CU360C System Controller on the LED display, set the MODE switch and power up the controller as described below.

■Prior to Setup

Do the following before entering the setup mode.

1.	Confirm that all necessary connections and switch set-
	tings are complete.
2.	With the power turned off, move bit #6 of the MODE
	switch on the rear to ON (administrator) position.
3.	Supply power to the controller.

■Buttons and Controls used for Setup

The following buttons and joystick operations are used in the setup operation. There are three ways to select a para- meter, but the following pages only describe the selection by use of the joystick. Instead of operating the joystick, you can enter the number enclosed in brackets with the numer- ic keys or press the plus and minus buttons.

4.	Turn on the power of cameras and other system units.
5.	The LCD displays [SEtUP]. The controller is ready to
	enter the setup mode.

When setup is completed, restore the switch to its original position.

1.With the power turned off, move bit #6 of the MODE switch on the rear to OFF (operator) position.

2.Supply power to the controller.

0 9

CAM

SET

MON

ESC

LR

DOWN

UP

L R

UP

R or

	DOWN
	UP
L	R	or
	DOWN

Numeric buttons: To select a parameter To enter a password or parameter

CAM/SET button: To confirm the selected menu, selected parame- ter or entered password To enter a submenu

MON/ESC button: To return to the previous

menu

Up: To select a setup menu

Down: To select a setup menu

STILL

Left: To decrease the parameter

–

EL-ZOOM

Right: To increase the parameter

+

17