Panasonic WV-CU360C manual Setup Procedures

■Setup Procedures

Set up the baud rate and parity check mode for the controller while observing the LED on the front panel.

Menu		Setup Menus			Parameter Selection (default*)
	LED Display	Reading	Function
Selection
				CAM
		Setup	Initial		LED prompts you to enter pass-
			Display		word
				SET
No					Enter a 5-digit password,
		Administrator	Authorization		press CAM (12345*)
OK		Password
	blinking	Prompt
					SET
				Press
Move Joystick			Baud Rate	twice	(1) 2 400 (2) 4 800 (3) 9 600*
		Speed
UP and down
			(bps)	CAM	(4) 19 200
to select
L	R			SET
DOWN				MON
UP		Parity	Parity Check		(1) None* (2) Even
L	R
				ESC

●Administrator Authorization

1.Press the CAMERA (ENTER) button while [SEtUP] is displayed. The [- - - - -] prompt appears.

2.Enter a password using the numeric buttons, then press the CAMERA (ENTER) button.

The default setting is [12345].

3.If the password entered is valid, [SPEED] appears. If password entry failed, the menu returns to [SEtUP].

Note: Selecting a slower rate (e.g., 2 400 bps) will delay the response time (e.g., the time until an acti- vated alarm is reset).

3.Press the CAMERA (ENTER) button to validate the selection.

4.Press the CLEAR(ESC) button to return to the [SPEED] menu.

●Baud Rate

In this menu, the communication speed (bps: bits per sec- ond) is selected. The communication speed should match that of the WJ-SX850.

1.Display [SPEED], and press the CAMERA (ENTER) button twice.

2.Select a parameter entering a bracket-enclosed num- ber, e.g., (3), moving the joystick.

The default setting is 9 600 bps.

(1)2 400: 2 400 bps

(2)4 800: 4 800 bps

(3)9 600: 9 600 bps

(4)19 200: 19 200 bps

●Parity

In this menu, the parity check mode is selected.

1.Display [PrtY] and press the CAMERA (ENTER) button twice.

2.Select a parameter with the joystick. The default setting is None.

n:None

E:Even parity

3.Press the CAMERA (ENTER) button to validate the selection.

4.Press the CLEAR(ESC) button to return to the [SPEED] menu.

Note: The baud rate and parity check mode of the WJ- SX850 and the controller must be the same, otherwise data communications will not function.

74