
OPERATING PROCEDURES (For WJ-SX350)
This section describes only some important operations such as login, logout, and different operations from the front panel of the
Please refer to the manual included with the
●Logout
1.Type 00 using the numeric button, then press the FUNCTION button. The LOGIN indicator turns off.
FUNCTION
■Login & Logout
●Login
1.Type your registered operator number (a maximum of 15 digits) using the numeric buttons, then press the CAM/SET button. If login has been successful, the LOGIN indicator lights up. If it has failed, another attempt can be made when the PROHIBITED indicator goes off after 2 seconds.
■Lens Control (Auto Focus Operation)
The following function requires the use of a camera with auto focus capability, such as the Panasonic
1. | Select the desired monitor and camera. |
2. | Press the FOCUS NEAR and FAR buttons simultane- |
1
4
7
MON
2
5
8
0
3
6
LOGIN
9
CAM
ously to automatically adjust the lens focus on the |
selected camera. |
FOCUS
NEAR |
|
|
|
|
| FAR |
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
AUTO FOCUS
ESCSET
2.Type your registered password (a maximum of 5 digits) using the numeric buttons, then press the CAM/SET button. If password entry has been successful, the LOGIN indicator changes from blinking to steady light. If it has failed, another attempt can be made when the PROHIBITED indicator goes off after 2 seconds.
1 | 2 | 3 |
4 | 5 | 6 |
|
| LOGIN |
7 | 8 | 9 |
MON |
| CAM |
| 0 |
|
ESC |
| SET |
■Pan/Tilt Control (Camera Position Operation)
The following function requires the use of a camera with preset panning capability, such as the Panasonic WV- CS854.
1.Select the desired monitor.
2.Select a registered camera position number using the numeric buttons.
3.Press the ALT button (indicator light on), then press the PRESET POSI button to activate the camera to move to the preset position.
PRESET
ALTPOSI
CAM
POSI
62