Panasonic WV-CU360C manual For version 6.00 or later, set the switches as shown below

■Controller Number Setting

Set this switch always to 1 when using the System Controller with the WJ-SX350.

9	0	1
8		2
7		3
6	5	4

CONTROLLER No.

●Switch Setting Procedures

Set the MODE DIP switch and CONTROLLER NO. switch as follows.

1.Remove the DC plug from the rear of the controller.

2.Set the MODE switches.

Bit 1 through 3 should match the version of the WJ- SX350 installed in your system. Open the SETUP MENU of the WJ-SX350 and check the version shown in the upper right corner of the menu.

S E T U P M E N U 6.xx/1.xx

P R O G R A M

O P E R A T O R

S Y S T E M

C A M D A T A L O A D

C A M E R A T I T L E

C A M – P O S I M A P

F U N C T I O N K E Y

For version 6.00 or later, set the switches as shown below.

OFF

ON

1 2 3 4 5 6 7 8

MODE

•Bit 1 should be set to OFF*.

•Bit 2 should be set to ON.

•Bit 3 should be set to ON.

For version 1.xx, set the switches as shown below.

OFF

ON

1 2 3 4 5 6 7 8

MODE

•Bit 1 should be set to OFF*.

•Bit 2 should be set to ON.

•Bit 3 should be set to OFF*.

Bits 4 through 8 are not version related.

•Bit 4 should be set to OFF*.

•Bit 5 should be set to ON*.

•Bit 6 should be set to OFF* (Operator) normally, or ON (Administrator) when setting up the controller.

•Bit 7 should be set to OFF*. Baud rate selection is automatic.

•Bit 8 should be set to OFF* normally.

3.Connect the DC plug to the controller.

59