Panasonic WV-CU360C manual Setup Procedures For System, Prior to Setup

SETUP PROCEDURES (For System 850)

To display the setup menus for the WV-CU360C System Controller on the LED display, set the MODE switch and power up the controller as described below.

■Prior to Setup

Do the following before entering the setup mode.

1.Confirm that all necessary connections and switch set- tings are complete.

2.With the power turned off, move bit #6 of the MODE switch on the rear to ON (administrator) position.

3.Supply power to the controller.

4.Turn on the power of cameras and other system units.

5.The LCD displays [SEtUP]. The controller is ready to enter the setup mode.

■Buttons and Controls used for Setup

The following buttons and joystick operations are used for setup.

0 9 Numeric buttons: To select a parameter

CAMERA	CAM (ENTER) button: To execute modes
(ENTER)
	and parameters
AUTO	To enter a submenu
PAN

CLEARCLEAR (ESC) button: To return to the previ-

(ESC)

ous menu

EXIT

Operator mode

OFF

ON

1 2 3 4 5 6 7 8 1 2 3

MODE

DC 9V IN

				OFF
				ON
4	5	6	7	L	R
				8
MODE					DOWN
Administrator mode					UP
				L	R
					UP
					R

DOWN

UP

L R

Up: To select a setup menu

Down: To select a setup menu

Left: To decrease the parameter

Right: To increase the parameter

DOWN

When setup is completed, restore the switch to its original position.

1.With the power turned off, move bit #6 of the MODE switch on the rear to OFF (operator) position.

2.Supply the power to the controller.

73