Panasonic WV-CU360C Controller Number Setting PS Data, Mode Switch Setting for System Example

●MODE Switch Setting for System Example 2

The MODE switch needs to be set prior to operating a sys- tem connected as shown in Example 2.

OFF

ON

1 2 3 4 5 6 7 8

Bit 3 should be set to OFF.

Bit 5 should be set to OFF when the controller is placed in an intermediate position, or set to ON when it is con- nected at the chain end.

■Controller Number Setting (PS • Data)

A 10-position rotary switches provided on the rear for spec- ifying the unit number of the WV-CU360C controller in a PS • Data system.

1.Remove the DC plug from the rear of the controller.

2.Use a screw driver to rotate the switch so that the arrow comes to the number you wish.

9	0	1
8		2
7		3
6	5	4

CONTROLLER No.

3. Connect the DC plug to the controller.

Controller No. Switch of WV-CU360C	Controller No.
0	Reserved
1	1
2	2
3	3
4	4
5	5
6	6
7	7
8	8
9	Reserved

Notes:

•Set the switch to #1 when a single controller is used in the system.

•Specify a unique number for each controller when con- necting multiple controllers in the system. One con- troller within the multiple controller system must be assigned the number 1.

•Positions #0 and #9 are reserved and cannot be used.

16