●Housing/AUX Control
When your system includes a camera housing, the defroster and wiper equipped in it are controlled. When a Receiver is installed in the system, an auxiliary device con- nected to it such as a buzzer or lamp will be also con- trolled.
8Defroster
Press the DEF/AUX 2 button to enable or disable defroster operation for the selected camera. The DEF/AUX 2 indica- tor next to the button is lit while it is in operation.
DEF
AUX 2
8Wiper
Press the WIPER/AUX 1 button to enable or disable wiper operation for the selected camera. The WIPER/AUX 1 indi- cator next to the button is lit while it is in operation.
WIPER
AUX 1
Note: To prevent early wiper wear, be sure to turn off the wiper whenever it is not needed, or before selecting another camera for viewing.
8Auxiliary 1/2
1.Press the SHIFT button to turn the SHIFT indicator on.
2.Press the WIPER/AUX 1 or DEF/AUX 2 button to enable or disable the auxiliary function for the selected camera. The respective indicator next to the button is lit while it is in operation.
| DEF |
SHIFT | AUX 2 |
| WIPER |
AUX 1
Note: Auxiliary control may be ignored while zooming, focusing or panning/tilting is in operation.
■Data Multiplex Unit Control
When more than one Data Multiplex Unit are connected with the controller as shown in System Connection Example 2 on page 14, you can select a camera directly with the camera number, without typing a system unit address.
●Setting
Camera numbers are specified by the UNIT switch or in the setup menu for the
For further details, refer to the manual included with the Data Multiplex Unit.
Unit Address | Camera Number |
of |
|
|
|
1 | 1, 2, 3, 4 |
|
|
2 | 5, 6, 7, 8 |
|
|
3 | 9, 10, 11, 12 |
|
|
4 | 13, 14, 15, 16 |
|
|
When more than one controller is connected in the system, remember settings are needed for the MODE DIP switch and CONTROLLER NO. switch of the controllers as described on page 16.
●Camera Selection
1.Press a camera number using the numeric buttons.
MONCAM
ESC LOGOUT SET
2.Press the CAM/SET button.
CAM
SET
28