Panasonic WV-CU360C manual Data Port Connection PS Data, Internal Diagram, Basic Connection

Example 2 shows 4 Data Multiplex Units connected with 16 combination cameras, and 4 System Controllers.

4 cameras can be connected to one Data Multiplex Unit

Channel 1 Channel 2 Channel 4

Up to 4 Data Multiplex Units

WJ-MP204C

Channel 13

Channel 14 Channel 16

Unit address 1

Controller No. 1

Data Multiplex Unit WJ-MP204CData Multiplex Unit WJ-MP204Data Multiplex Unit WJ-MP204

	Unit	Unit
	address 2	address 4
	Controller No. 2	Controller No. 4
System Controller WV-CU 360	System Controller WV-CU 360	System Controller WV-CU 360

See page 16 for MODE switch and

CONTROLLER NO. switch settings.

WV-CU360C Up to 4 System Controllers

●DATA Port Connection (PS • Data)

Data ports are connected with RS-485 cables among devices using the PS • Data protocol as follows.

Notes: When using cables other than those supplied, make sure to use shielded 4-wire twisted pair cable suitable for RS-485 communication.

• Internal Diagram

	No.	Data Flow		Name	No.		TX (B)
1	1	–		GND	1	Controller end
	2	WJ-MP204C ←	WV-CU360C	TX(B)	2	1	TX (A)
	3	WJ-MP204C ←	WV-CU360C	TX(A)	3		RX (B)
	4	WJ-MP204C →	WV-CU360C	RX(B)	4
6	5	WJ-MP204C →	WV-CU360C	RX(A)	5		RX (A)
						6
	6	–		GND	6

• Basic Connection

Data Multiplex Unit	System Controller
WJ-MP204C	WV-CU360C

DATA

Termination:

ON

Termination:

ON

RS-485 Cable

14